-connection unit (input valve unit) - provides supply from the gas pipeline and its accounting;
-gas pre-treatment unit - provides preparation of gas parameters to the level required by the compression technology used;
-compression unit (compressor unit with electric motor, made in Italy)
- compressor lubrication system;
-compressor cylinder cooling system, including a stand-alone, dry-cooler;
-CNG preparation unit - brings the compressed gas parameters to the quality according to GOST 27577;
-gas drying unit;
-the reduction unit reduces the gas pressure to 200 atm;
-accumulation unit - accumulates a reserve of CNG for filling vehicles
-gas detection system;
-lighting system;
-block-box heating system;
-oil heating system;
-rain shelter (block-box);
-regenerative drying with manual control;
-chiller;
-chiller compartment heating system;
-valve control system.

Request a Quote

The automobile gas filling compressor station (hereinafter referred to as the AGNKS) is designed for filling vehicles with compressed gas fuel at a pressure of 200 bar. It is made in a block-modular design with maximum factory readiness, which does not require additional shelters from precipitation. All the equipment of the filling station is installed in two all-welded 20-foot containers: an explosion-proof compressor unit with an electric drive, a container for the drying unit, and a separate explosion-proof dry cooler, which are connected by a common automated control system equipped with an advanced AI-based intelligent gas station control system. It is quickly assembled, takes up little space, and can be easily moved as a whole. It only requires gas, water, and electricity connections.
Additionally, upon the customer's request, we can provide a CNG storage unit in the basic module and 1 or 2 fuel dispensers from BlueSky or an equivalent company. This CNG filling station is suitable for airports, large construction sites, vehicle fleets, logistics companies, farms, etc."#$%^&" "#$%^&"

All mechanical components of the compressors are made of C45 steel; shafts and rods are made of carbon steel; the gas piston is made of aluminum."#$%^&"